Profiles guide · Step 5 of 7

How to Set Up Profiles on a Timber Frame

On a timber frame job the frame is up before you arrive. That gives you something solid to fix the top of every profile to.

The order on site

First

The carpenter puts up the frame.

Then

You set out and lay the first course, and set the damp-proof course (DPC).

Now

The profiles go up — with a course of brick and the frame to fix to.

Fixing the bottom of the profile

Clamp the profile through the perp joint. Which clamp depends on how the brickwork is laid out at that corner:

Mortar already gone off, or coming back to a job? Use a nail-on clamp — External or Internal. Tap the nail into the perp or bed joint. No chiselling the mortar out.

Medium External Profile Clamp — BT Engineering bricklaying clamp for full brick external corners

Profile clamps through the perp joints at the base of each profile.

Fixing the top of the profile

Use the Top Clamp – Timber Veneer Adjustable. It adjusts left–right and in–out, so you can bring the profile dead plumb.

  1. Nail the two nail brackets to the timber frame.
  2. Thread the bar through both brackets.
  3. Fasten the clamp to the top of the profile.
  4. Put a level on the side face and adjust. Then on the front face and adjust. Take it in turns until both read plumb.

Why it matters: the line pulls on the profile. As you work up and tension the line, it would drag the profile inwards; the clamp holds it true. It works the same on internal and external corners. Spare nail brackets are sold separately.

Top Clamp Timber Veneer Adjustable — BT Engineering complete top clamp kit for timber frame brick veneer

The timber veneer top clamp nailed to the frame, holding the top of the profile.