Profiles guide · Step 4 of 7

How to Set Up Profiles on a New Build

Bare foundations, a set of drawings, and nothing standing to fix to. This is where profiles save the most work.

Step by step

  1. Mark the gauge. Use a gauge rod to mark the same gauge on every profile, from the same starting level.
  2. Stand a profile on every corner. With nothing to clamp to yet, hold the top with a Profile Stand or the 3 Way Timber Clamp. The profile stands on its own in free space.
  3. Plumb each profile both ways. Put a level on one face, then on the face at right angles, and adjust until both read plumb.
  4. Run the line with Dori Blocks. Lock a Dori Block to each profile at the gauge mark with its thumb screw, and run the line between them.
  5. Lay to the line. The profile holds the corner plumb; the line holds every course level and straight. There’s no need for a level on every brick.
  6. Clamp the profiles as the wall rises. Once there’s brickwork to hold, clamp the lower part of each profile through the perp joint — external clamps on quoins, internal clamps on internal corners. See the clamp guide.
  7. Secure the top. Fit the Top Clamp – Double Brick Adjustable. Its brackets clamp onto the brickwork or blockwork already built, and it adjusts left–right and in–out. It stops the line pulling the profile inwards as you work up.
  8. Move the Dori Blocks up a course and keep laying.
3 Way Timber Clamp — BT Engineering single-operator bricklaying profile clamp

Step 2  — Fresh slab with 3 Way Timber Clamp setup

Top Clamp Double Brick Adjustable Kit — BT Engineering UTOPIA bricklaying profile top clamp

Step 7 — The top clamp grips the masonry and holds the profile plumb.

Why a Dori Block, not a line block, on a profile

BT Line Block — bricklayer's UV-resistant line block for 50mm profiles and corners

Line block

Held on by the tension in the line. If the line snaps, the block drops — and because the line usually runs right round the job, every line block drops with it.

Dori Block — BT Engineering bricklayer's dual string line block for 50.8mm profiles

Dori Block

Fixed to the profile by a thumb screw. Snap the line and every Dori Block stays exactly where you set it, at the right gauge. The Long Sided Dori Block also lets the corner brick sit snug against the profile, flush with the line.